OTR

Does the VCM OTR COLD AIR INTAKE BUNDLE KIT FOR HSV CLUBSPORT VE LS2 LS3 6.0L 6.2 V8 will fit a 102mm throttle body?
Yes, this boot will be able to stretch over a 102mm throttle body. It may need a bit of lubrication to help fit properly.
There is no outlet fitting on the VCM OTR Cold Air Intake Bundle Kit to suit Holden L76 L98 6.0L V8 for the hose to connect to. What do we need to do about that?
The breather port on the OTR is optional depending on the configuration of the unit. If required, the installer can drill a hole in the designated location (as shown in the instructions or photo provided) and fit the supplied grommet that comes with the kit.
Does the ORSSOM OTR Cold Air Intake to suit Holden SIDI LF1 LLT 3.0L / 3.6L V6 fit a 2009 VE Omega Commodore with MAF sensors?
Yes, it does. Please note that this kit is designed for MAF sensor setups with circular cartridges. For MAFLESS setups, minor modifications will be required.
Is it safe to run the MAF-Less VCM Alloy OTR Cold Air Intake Kit to suit Holden LS1, L76, and L98 5.7L / 6.0L V8 engines?
Yes, it is safe. Running a MAF-less setup removes the sensor and screen from the intake, allowing for less restricted airflow. In this configuration, the engine uses manifold pressure to calculate fuel maps, which results in improved kilowatts, torque, and throttle response.
What is the difference between MAF and MAF-less OTR COLD AIR INTAKE?
The MAF OTR kit is for factory engine/standard setup. The MAF-less version includes couplers to eliminate the factory MAF and require a custom speed-density tune.
The ORSSOM OTR to suit VE-VF V6 SIDI LLT, LFX, LF1, LFW is it MAF or Mafless?
The ORSSOM OTR Cold Air Intake to suit Holden SIDI LF1 & LLT 3.0L / 3.6L V6 is designed as a MAF setup. It’s made to work with the factory MAF sensor (the circular cartridge type). For those running a MAFLESS tune, some modification or a different setup would be required.
Does the ORSSOM OTR Cold Air Intake to suit Holden Alloytec LY7, LE0, LW2 3.6L V6 (up to 5/2009) include all the parts needed for installation?
Yes, it does. All parts that require during installation are included in this kit. This kit Contains: Lower Injected filter box assembly, Top Injected filter cover, 3 x speed clips and screws, 2 x Air Flow Meter screws, Air Flow meter seal, 4 x M6 cover bolts / nylon washes / lock washers , K&N air filter (Re-usable / washable at every service), 1 x Rubber bellow, 1 x Hose clamp, Easy to follow fitting instructions (Installation time: approx. 45 minutes)
Does MACE sell an OTR to suit the VP 5.0L Commodore?
Unfortunately, we don't have an OTR that suits your vehicle at this point. However, we can help you with our cold air intake which can be shown in the link below.

View Product