MACE 1.9 HIGH RATIO ROLLER ROCKER KIT TO SUIT HOLDEN MONARO V2 SERIES I L67 SUPERCHARGED 3.8L V6

Mace 1.9 ratio roller rockers (up from 1.65) are suitable for Holden Commodore and similar platforms fitted with Ecotec (L36) or L67 supercharged V6 engines. This is a very cost effective way to bump up the performance of your vehicle, by increasing valve lift and allowing your engine to breathe much more efficiently.

Manufactured by a renowned engineering company you can be assured of the outstanding quality and workmanship of these remanufactured rockers.

Key Benefits:

• Gains of around 13 to 16kW are not uncommon. Higher in some cases where others mods have been undertaken.
• In addition to top end gains, excellent low to mid range power gains are also achieved with these rockers.
• Its an easy DIY mod and takes around two hours to be done unlike a complete cam change. A cam change can take a good part of a day and is more complex to undertake meaning higher installation costs along with the cost of a retune which these rockers don't require, potentially saving you thousands!
• Unlike some aftermarket rockers these don't require spring upgrades as they best preserve the factory valve train harmonics, to prevent them from having valve float, hurting power and causing engine damage.Even when valve springs are upgraded (which is a costly exercise) to prevent this valve float from occurring, power output drops because the engine has to work against these stiffer springs. Basically, it can be a case of spending more money for less power than what these rockers have to offer!

Contents:

• 1 X Bolt pack
• 1 X Assembly of 12 high ratio rocker
• 1 X Rocker lubricant
• 2 X Rocker pedestal

Vehicle Fitment Guide

Notes:

• Rockers with ratio higher than 1.9 are not suitable for use with an aftermarket camshaft unless the cam was designed for them because the excessive amounts of lift will potentially cause engine damage.
• These rockers alone are not recommended to be used in VY series Ecotec and L67 Supercharged V6 engines due to extra casting flash around the pushrod cavity. These engines must use a thin walled pushrod to gain the required clearance. A kit comprised of rockers and pushrods can be purchased through another listing.